Détecteurs réflex avec élimination de l’arrière-plan

Le détecteur réflex doit être orienté vers l’objet. La portée doit être réglée sur une distance située entre l’objet à détecter et l’arrière-plan. L’arrière-plan doit se trouver derrière la portée réglée au moins à une distance égale à la réduction de cette même portée du détecteur sur fond noir.

Reflexionslichttaster_Hintergrundausblendung_Diagramm.jpg

Pour les détecteurs réflex avec élimination de l’arrière-plan, on se réfère, pour un réglage optimal, au diagramme de la portée. Il indique la réduction de la portée sur fond blanc en fonction de la portée pour différents degrés de luminance de réflexion. Ceci indique de combien se réduit la distance de la portée sur fond noir ou gris par rapport à celle sur fond blanc. Si on reporte sur l’axe X du diagramme la valeur de la portée réglée sur fond blanc, on peut alors lire sur l’axe Y du diagramme la réduction de la portée sur fond noir ou gris. La réduction de la portée montre également de combien un objet noir ou gris doit au moins être éloigné d’un arrière-plan blanc.


Barrières lumineuses sans réflecteur

La barrière SmartReflect doit être alignée sur une pièce de la machine située à l’intérieur de la plage de détection. L’apprentissage de cette pièce de la machine est ensuite effectué par le processus Teach-in.

Il faut tenir compte que juste devant la pièce de la machine il existe une zone morte qui est automatiquement réglée lors de l’opération Teach-in. La zone morte est déterminée lors de la spécification de la plage de détection en % de la position de l’arrière-plan.

Diffuse sensors with intensity difference

With diffuse sensors operating by the intensity difference principle, the relative receiving signal is specified. This represents the signal level received from a white object as a function of the distance. Using this diagram, the sensing range can be determined for an object which is not white. The correction factor of the respective material is required for this purpose.

Reflexionslichttaster-Intensit-tsunterscheidung-Tabelle_EN.jpg
Correction factor

The material and surface properties of the object (representing the reflectivity) influence the switching distance of a diffuse sensor with intensity difference. To determine the corrected switching distance, the following values must therefore be applied to the relative receiving signal (KFs) or in approximation to the distance (KFd).

Products_Presence_Photoelectric_intensity_mounting_EN.png

Retro-reflective sensors

Each sensor has a separate excess gain curve. As the operating reliability depends heavily on the ambient conditions, it must be ensured that the sensor operates with the highest possible excess signal gain.

Products_Presence_Photoelectric_retro_reflective_mounting_v2.jpg

With narrow light beams as used in laser sensors, the size of the light spot on the reflector in relation to the triple structure is crucial factor when it comes to choosing the reflector or the reflective type. A special reflective type or reflector for laser sensors should be used for spot diameters of up to 1,5mm, while the use of reflectors with microstructures is recommended for spot diameters of up to 3 mm. It should also be ensured that the reflective type or reflector is not placed close to the focus.


Through beam sensors

The emitter and receiver must be aimed at each other. The narrower the angle of radiation and reception, the more accurately this must be conducted.


Product portfolio

To the top